 |
|
|
|
|
|
|
| |
Home >
Stramit Building Products >
Formwork
FORMWORK
Install, Maintain :
Index |
|
Walking
Take care when walking on Stramit Condeck HP® Decking, particularly if the surface has become wet. Wear suitable rubber-soled footwear at all times. Also note that, when first delivered, there may be traces of rolling oil present. It is possible to step either in the pans or on the ribs of Stramit Condeck HP® Decking but when walking use only the pans. Avoid walking on the edge sheet, or on rib ends.
Decking Placement
Stramit Condeck HP® Decking is easily placed by hinging the overlap edge of one sheet over the underlap edge of the previous sheet. If the decking is used as a platform for laying subsequent sheets, designated propping must be positioned first.
Fixing
Once decking panels are laid they should immediately be secured against possible wind uplift. Typically use one fixing per pan at end supports, and one fixing every third pan at permanent internal supports. Self-drilling and tapping screws or powder actuated drive pins are commonly used. These fixings should be adjacent to the decking ribs. In exposed conditions additional fixing may be required. Shear studs, if used, attached immediately after decking placement, or puddle welds, will provide wind uplift resistance. |
All products contained herein © Stramit Building Products. Page layout © 1996-2008 Architecture Media (Selector) Pty Ltd.
All rights reserved.
|
|
|
|
Photographs