Home > Pyrotek > Silentstep Acoustic Underlay

Silentstep will take a little extra time to install, however, the benefits experienced by your customer will far exceed the additional effort. Use standard Domestic Carpet Gripper unless otherwise directed. Lay waffle side of underlay on to the floor surface. Butt edges of Silentstep firmly together; underlay tape is necessary. Silentstep should not be stapled to timber floors or attached by adhesive to concrete floors. By doing so, the acoustic properties will be reduced. The products has sufficient weight to remain in a firm position during the fitting of the carpet. Cut in as per normal rubber underlay installation. Make certain the carpet is firmly attached to leading gripper pins. Bolster carpet between far side gripper edge and skirting boards. Once again, check that the carpet is firmly attached to the gripper.

All products contained herein © Pyrotek. Page layout © 1996-2008 Architecture Media (Selector) Pty Ltd. All rights reserved.