 |
|
|
|
|
|
|
| |
Home >
Gainsborough Architectural Hardware >
Exit Devices
EXIT DEVICES
Install, Maintain :
Index |
|
Maintenance
It is important that all panic and emergency exit devices are inspected and maintained properly to ensure safety is maintained when exiting a building in any situation.
To ensure the panic and emergency exit hardware is functioning correctly, it is recommended that a weekly inspection is made to check for damage, operation and that the keeps are kept free of any obstruction. Then every three months a check should be made to ensure all the fixings are secure and that the units are lubricated where necessary.
Fixing/Installation
Installation instructions are supplied with all the Exidor Panic and Emergency Exit Hardware. Provided the instructions are followed and the units are fitted by a competent person, the Exidor range will offer a high degree of safety and security. No responsibility can be accepted by the manufacturer if the installation instructions are not followed.
All bars and shoots are cut to the exact size on site and each unit is supplied with loose end plugs and caps. For the touchbar units, they are supplied in two lengths to suit most door application widths. For doors that require a non standard size, the manufacturer will make them to the sizes given. This will eliminate the problem of parts going missing on site.
Unless specified, all the Exidor range is supplied with all the necessary fixings for timber frames and doors, however for alternative fixings, please contact the manufacturer.
Construction
Standard Panic and Emergency Exit Hardware
The main body and slave unit are of die cast aluminium with extruded aluminium guides. The internal shoots and shoot ends are of solid steel with tubular steel shoots and the latch bolts are in extruded brass.
Touchbar Panic Hardware
The Touchbar and its main body are of rolled steel section with internal components manufactured in zinc plated steel and pressure die cast aluminium. The latch bolts are of stainless steel including the Pullman Catches. The covers of the Pullman Catches are of die cast aluminium.
Guarantee
To support the high quality and first class engineering that has gone into the Exidor range, Gainsborough gives a guarantee that should any component of the Panic and Emergency Exit Hardware prove to be defective to either faulty manufacture, workmanship or defects in the material then it will replaced free of charge.
|
All products contained herein © Gainsborough Architectural Hardware. Page layout © 1996-2008 Architecture Media (Selector) Pty Ltd.
All rights reserved.
|
|
|
|
Photographs